Home / Capabilities
Specialist depth, where it counts.
Beyond installation and maintenance, our engineers study, design and rebuild: from power system stability to underground drill rigs.
Engineering consultation
Find the problem before you buy the fix.
Poor power quality shows up as nuisance trips, overheating motors, failing drives and penalty tariffs. We measure, model and design so you put money in the right place.
- Power quality measurement & power factor improvement
Logging of harmonics, voltage events and power factor, then correction equipment sized to the measured load.
- Voltage stability studies & improvement
Modelling of how your network behaves under load swings and motor starts, and how to keep voltage within limits.
- Transient stability studies & improvement
How generators and large drives ride through faults and switching events.
- Transmission, earthing & distribution design
Network layout, earthing systems, cable and conductor sizing.
- Network & grid improvements
Reconfiguration, reinforcement and protection coordination for growing sites.
- Power electronics for drives
Variable speed drive selection, application and troubleshooting.
- Power electronics for system stability
Voltage and transient stability support using power electronic devices.
- Custom power electronic devices & systems
Design and implementation where an off-the-shelf product doesn’t fit.
- Solar power design & implementation
PV system design, plus energy management and grid connection for solar.
- Lighting audit & improvement
Surveys of lux levels and consumption, with retrofit recommendations.
- Compressor consultation
Air demand analysis, system sizing and compressor selection.
- Electrical engineering general consultation
Independent engineering advice for owners and contractors.
Best practice
Measure before you correct. A one- to two-week power quality log taken at the main incomer, covering a full production cycle, shows whether you need plain capacitor banks, detuned banks or active harmonic filtering. Installing standard capacitors on a network with drive harmonics can cause resonance and capacitor failure.

Compressor airend overhaul for drills
Overhaul the airend. Keep the budget.
The airend is the heart of a drill compressor, and often the most expensive single part. When it wears, we offer a competitive, cost-effective overhaul as an alternative to buying a new one.
Replace
- New airend at full OEM price
- Long import lead times
- The worn unit is scrapped
EMK overhaul
- Lower cost than a new airend
- Bearings, seals and rotor clearances restored
- Your existing unit goes back into service
Mining & heavy equipment
Repair, rebuild and maintain: above and below ground.
Underground fleets work in the hardest conditions there are. We keep rigs, loaders and locomotives productive, and train your people to do the same.
- Electro-hydraulic rig maintenance and repair
- Electro-hydraulic rig rebuild, rehabilitation and commissioning
- Retrofitting of rigs for optimum performance
- Underground substation construction
- Underground trolley line installation
- Hydraulic pump and motor repair
- Training on drill rig maintenance and repair
- Hydraulic drill rig drifter repairs (Atlas Copco and Sandvik)
- Mobile loader rebuilds and underground locomotive rehabilitation

Have a problem that needs a study?
Tell us the symptoms. We’ll recommend measurements, a study or a direct fix.